帳號:
密碼:
首頁 | 元件(模組) | 開發板 | 開發工具(箱) | 代理商 | 原廠 | 訂單狀態 | 客戶服務 |
新品搜尋 ﹕ 方法﹕
 
NXP-LPC1857JET256
原廠/品牌: NXP 上架日期: 02/28
供應商: NXP 產品類別: MCU

     The LPC185x/3x/2x/1x are ARM Cortex-M3 based microcontrollers for embedded applications. The ARM Cortex-M3 is a next generation core that offers system enhancements such as low power consumption, enhanced debug features, and a high level of support block integration.

     The LPC185x/3x/2x/1x operate at CPU frequencies of up to 180 MHz. The ARM Cortex-M3 CPU incorporates a 3-stage pipeline and uses a Harvard architecture with separate local instruction and data buses as well as a third bus for peripherals. The ARM Cortex-M3 CPU also includes an internal prefetch unit that supports speculative branching.

     The LPC185x/3x/2x/1x include up to 1 MB of flash and 136 kB of on-chip SRAM, 16 kB of EEPROM memory, a quad SPI Flash Interface (SPIFI), a State Configurable Timer (SCT) subsystem, two High-speed USB controllers, Ethernet, LCD, an external memory controller, and multiple digital and analog peripherals.

零件編號 封裝 規格說明 單價 庫存 最小量 購量
LPC1857JET256,551 SOT360-1 32-bit ARM Cortex-M3 MCU; up to 1 MB flash and 136 kB SRAM; Ethernet, two High-speed USB, LCD, EMC       洽詢 0 週 1 洽詢
功能和優勢

  • Processor core
    • ■ ARM Cortex-M3 processor, running at CPU frequencies of up to 180 MHz
    • ■ ARM Cortex-M3 built-in Memory Protection Unit (MPU) supporting eight regions
    • ■ ARM Cortex-M3 built-in Nested Vectored Interrupt Controller (NVIC)
    • ■ Non-maskable Interrupt (NMI) input
    • ■ JTAG and Serial Wire Debug, serial trace, eight breakpoints, and four watch points
    • ■ Enhanced Trace Module (ETM) and Enhanced Trace Buffer (ETB) support
    • ■ System tick timer
  • On-chip memory
    • ■ Up to 1 MB on-chip dual bank flash memory with flash accelerator
    • ■ 16 kB on-chip EEPROM data memory
    • ■ 136 kB SRAM for code and data use
    • ■ Multiple SRAM blocks with separate bus access
    • ■ 64 kB ROM containing boot code and on-chip software drivers
    • ■ 64 bit of One-Time Programmable (OTP) memory for general-purpose use
  • Clock generation unit
    • ■ Crystal oscillator with an operating range of 1 MHz to 25 MHz
    • ■ 12 MHz internal RC oscillator trimmed to 2 % accuracy over temperature and voltage (1 % accuracy for Tamb = 0 °C to 85 °C)
    • ■ Ultra-low power RTC crystal oscillator
    • ■ Three PLLs allow CPU operation up to the maximum CPU rate without the need for a high-frequency crystal. The second PLL can be used with the High-speed USB, the third PLL can be used as audio PLL
    • Clock output
  • Configurable digital peripherals
    • ■ State Configurable Timer (SCT) subsystem on AHB
    • ■ Global Input Multiplexer Array (GIMA) allows to cross-connect multiple inputs and outputs to event driven peripherals like timers, SCT, and ADC0/1
  • Serial interfaces
    • ■ Quad SPI Flash Interface (SPIFI) with 1-, 2-, or 4-bit data at rates of up to 52 MB per second
    • ■ 10/100T Ethernet MAC with RMII and MII interfaces and DMA support for high throughput at low CPU load. Support for IEEE 1588 time stamping/advanced time stamping (IEEE 1588-2008 v2)
    • ■ One High-speed USB 2.0 Host/Device/OTG interface with DMA support and on-chip high-speed PHY (USB0)
    • ■ One High-speed USB 2.0 Host/Device interface with DMA support, on-chip full-speed PHY and ULPI interface to an external high-speed PHY (USB1)
    • ■ USB interface electrical test software included in ROM USB stack
    • ■ Four 550 UARTs with DMA support: one UART with full modem interface; one UART with IrDA interface; three USARTs support UART synchronous mode and a smart card interface conforming to ISO7816 specification
    • ■ Up to two C_CAN 2.0B controllers with one channel each. Use of C_CAN controller excludes operation of all other peripherals connected to the same bus bridge
    • ■ Two SSP controllers with FIFO and multi-protocol support. Both SSPs with DMA support
    • ■ One Fast-mode Plus I2C-bus interface with monitor mode and with open-drain I/O pins conforming to the full I2C-bus specification. Supports data rates of up to 1 Mbit/s
    • ■ One standard I2C-bus interface with monitor mode and standard I/O pins
    • ■ Two I2S interfaces with DMA support, each with one input and one output
  • Digital peripherals
    • ■ External Memory Controller (EMC) supporting external SRAM, ROM, NOR flash, and SDRAM devices
    • ■ LCD controller with DMA support and a programmable display resolution of up to 1024H x 768V. Supports monochrome and color STN panels and TFT color panels; supports 1/2/4/8 bpp Color Look-Up Table (CLUT) and 16/24-bit direct pixel mapping
    • ■ SD/MMC card interface
    • ■ Eight-channel General-Purpose DMA controller can access all memories on the AHB and all DMA-capable AHB slaves
    • ■ Up to 164 General-Purpose Input/Output (GPIO) pins with configurable pull-up/pull-down resistors
    • ■ GPIO registers are located on the AHB for fast access. GPIO ports have DMA support
    • ■ Up to eight GPIO pins can be selected from all GPIO pins as edge and level sensitive interrupt sources
    • ■ Two GPIO group interrupt modules enable an interrupt based on a programmable pattern of input states of a group of GPIO pins
    • ■ Four general-purpose timer/counters with capture and match capabilities
    • ■ One motor control PWM for three-phase motor control
    • ■ One Quadrature Encoder Interface (QEI)
    • ■ Repetitive Interrupt timer (RI timer)
    • ■ Windowed watchdog timer
    • ■ Ultra-low power Real-Time Clock (RTC) on separate power domain with 256 bytes of battery powered backup registers
    • ■ Event recorder with three inputs to record event identification and event time; can be battery powered
    • ■ Alarm timer; can be battery powered
  • Analog peripherals
    • ■ One 10-bit DAC with DMA support and a data conversion rate of 400 kSamples/s
    • ■ Two 10-bit ADCs with DMA support and a data conversion rate of 400 kSamples/s. Up to eight analog channels total. Each analog input is connected to both ADCs
  • Unique ID for each device
  • Power
    • ■ Single 3.3 V (2.2 V to 3.6 V) power supply with on-chip internal voltage regulator for the core supply and the RTC power domain
    • ■ RTC power domain can be powered separately by a 3 V battery supply
    • ■ Four reduced power modes: Sleep, Deep-sleep, Power-down, and Deep power-down
    • ■ Processor wake-up from Sleep mode via wake-up interrupts from various peripherals
    • ■ Wake-up from Deep-sleep, Power-down, and Deep power-down modes via external interrupts and interrupts generated by battery powered blocks in the RTC power domain
    • ■ Brownout detect with four separate thresholds for interrupt and forced reset
    • ■ Power-On Reset (POR)
  • Available in LQFP208, LBGA256, LQFP144, and TFBGA100 packages
應用

  • ■ Industrial
  • ■ Consumer
  • ■ White goods
  • ■ RFID readers
  • ■ e-Metering

新品討論
  產品捷報
貿澤電子7月發表超過287項新產品
安森美半導體推動感知、聯接、照明、致動方案及設計資源
艾訊推出視覺檢測專用USB 3.0影像擷取卡AX92321
ATEN推出新KVM over IP訊號延長器 採用中控室分散式架構
大聯大品佳推出安森美半導體NCV78247的汽車矩陣式大燈系統
  最新活動
英特爾工業物聯網技術研討會
台灣國際醫材製造及零組件展
百貨及量販店業節能技術研討會
工業4.0數位化與雲端化創新論壇
南科3D列印智造群聚發表會
刊登廣告 新聞信箱 讀者信箱 著作權聲明 隱私權聲明 本站介紹

Copyright ©1999-2019 遠播資訊股份有限公司版權所有 Powered by O3
地址:台北市中山北路三段29號11樓 / 電話 (02)2585-5526 / E-Mail: webmaster@ctimes.com.tw